version 3 of SEQ16
Slave Mode
There is a “S” switch next to “SEQ2/3”.
Turn on this switch, SEQ2/3 becomes slave mode.
In slave mode, SEQ2/3 follows clock of SEQ1.
Clock Reset(test version)
This function is test version.
So there are some unexpected behaviors.
There is a menubox next swing parameter.
You can set reset interval by this menubox.
If you set 1bar, clock of seq1 will be reset per 1bar.
LFO(phase, noise)
added phase control knob and noise amount knob
Signal Path
Sequencer1
sequencer produces midi note outputs
Knob = midi note of each step
Step Behavior
In this section, you can define behavior of each step.
From the top:
Oct = octave of each step(-1, 0, +1)
Step Size = step size of each step(/4, /3, /2, x1, x2, x3, x4)
Prob = probability of each step(0 to 100%)
Tie = tie on/off
Skip = turning on this switch, that step will be skipped
Lock = turning on this switch, that step will not be affected randomize
Mute = mute on/off
Transport Settings of SEQ1
Power Switch = seq1 on/off
MenuBox1 = sequencer speed
“> < ><1 ><2” = sequencer directions
Strt = start point of sequencer
Size = step size of sequencer
MenuBox2 = root note
MenuBox3 = scale
Goct = global octave(-2 to +2)
TP = transpose
Knob Range = range of each note knob
Swing = swing amount
Velo = velocity
Gate = gate(0 to 100%)
Randomize/Clear Step State
“R” = randomize
“C” = clear
Sequencer2/Sequencer3
target parameter of seq2/3 is assignable
Parameter Assign and Range/Jitter
“SEQ MIDI MAP” = category of target parameter
MenuBox = target parameter
Target Parameters
SEQ
Velocity = velocity of midi output
Gate = gate time
Shift = timing shift
Prob = probability of triggered
MIDI
MW = modwheel
PB = pitchbend
AT = after touch
CC = midi CC
PC = program change
RangeMin = minimum value of output
RangeMax = maximum value of output
Jitter = randomness of output value
LFO
SEQ16v3 has 2 LFO units.
You can modulate target parameter.
Power Switch = lfo unit on/off
“Sin Up Dwon Squ Tri Rnd” = output waveform of lfo unit
Rate = lfo speed
“S” = sync switch of lfo rate
Depth = -100 to 100%
Target Parameter
Note = note (modulating output value of Sequencer1)
Velo = velocity
Gate = gate time
Shift = timing shift
Prob = probability
SEQ2/SEQ3 = modulating output values of sequencer2/3
MW = modwheel
PB = pitchbend
AT = after touch
CC = midi control change
PC = program change
Transposer
You can control transpose value from this sequencer unit.
Knob = set transpose value of each step(-12 to +12 semitone)
“R C” = randomize/clear knob value
Save/Load Snapshots
You can make 8 snapshots.